As a rule of thumb 1 of our 25kg bags will cover an area of 0.25m to a recommended depth of 50mm.

Also, How much Builders mix do I need for 1m3 of concrete?

To make 1 cubic metre of conrete you will need 6x 40kg bags of cement to every 1m3 of builders mix.

Hereof, How many bags of concrete do I need for 1 cubic meter?

How many bags of cement are needed to mix one cubic meter of concrete? A. One cubic meter of concrete is equal to 1.308 cubic yards of concrete. If there are 5 1/2 bags of cement in 1 cubic yard of concrete, there would be 7.2 bags in 1 cubic meter of concrete.

Also to know How many bags of concrete do I need for a 10×10 slab? The volume of concrete required for a 10- by 10-foot slab depends on the diameter of the slab. For a 4-inch slab, either eight 60-pound or six 80-pound bags are required, while for a 6-inch slab, either 12 60-pound or nine 80-pound bags are necessary.

How many bags of concrete do I need for 2 yards?

If you’re using 50lb bags of concrete, you’ll need 72 bags to make a yard. If you’re using 60lb bags of concrete, you’ll need 60 bags to make a yard. If you’re using 80lb bags of concrete, you’ll need 45 bags to make a yard.

18 Related Questions Answers Found

What is the strongest concrete mix ratio?

A strong concrete mix would be something like 1:3:5 (Cement, Sand, Coarse Gravel). In this case, both the sand and gravel are the aggregate. In pre-mix concrete, the aggregate is already mixed with the cement.

How many bags of cement is 1m3?

Approximately 29 bags are required for 1m3 of cement.

How many bags of cement do I need for 1 cubic meter?

One cubic meter of concrete is equal to 1.308 cubic yards of concrete. If there are 5 1/2 bags of cement in 1 cubic yard of concrete, there would be 7.2 bags in 1 cubic meter of concrete. These are the 94 pound bags of portland cement or 42.64 kg bags of cement. Join in and write your own page!

How many 50kg bags of cement are in a cubic meter?

Procedure To Calculate Cement Bags In 1 Cubic Meter:

Weight of 1 bag cement = 50 kg. =0.0347 cum. = 6.25 bags. Note: You can use the same formula for calculating cement for other nominal mixes.

How much sand and cement do I need for 1 cubic meter of concrete?

1 Cubic Meter of Concrete

1m3 of concrete = 150l water + 250kg cement + 700kg sand + 1200kg aggregates.

How do you mix 1 cubic meter of concrete?

For typical domestic use, 1 cubic metre of concrete at 3500 psi (25 MPa) can be readily created by mixing seven 50 kg bags of cement with 0.7 cubic metres of sand and 0.7 cubic metres of stone aggregate. Concrete of this strength is ideal for patio slabs, footpaths and steps.

How many bags of concrete do I need for a 10×10 slab 4 inches thick?

Regarding this, “how many bags of concrete do I need for a 10×10 slab of 4 inch thick?”, at 4 inches thick, generally you will need 49 bags of 90lb ready mix concrete, 56 bags of 80lb concrete, 74 bags of 60lb concrete or 111 bags of 40lb ready mix concrete for a 10×10 slab.

What is a cheaper alternative to concrete?

There are a few different types you can find in the home improvement store that can replace concrete cement used for driveways and walkways. These include pea gravel, crushed stone, and quarry process. Cheaper than other surface materials and low-cost to install.

How many feet does a 80lb bag of concrete cover?

6 cubic feet for an 80 lb bag.

Should you put plastic under concrete?

A concrete vapor barrier is any material that prevents moisture from entering a concrete slab. Vapor barriers are used because while fresh concrete is poured wet, it’s not supposed to stay that way. It needs to dry and then stay dry to avoid flooring problems. … This is why a vapor barrier under concrete is essential.

How thick should a concrete driveway be?

As for thickness, non-reinforced pavement four inches thick is standard for passenger car driveways. For heavier vehicles, a thickness of five inches is recommended. To eliminate standing water, the driveway should be sloped towards the street a minimum of one percent, or 1/8 inch per foot, for proper drainage.

Does adding more cement make concrete stronger?

A mix with little water and more concrete mix will be dryer and less workable but stronger. … To make the concrete stronger, add more cement or less sand. The closer you bring the ratio to an even one-to-one of sand to cement, the stronger the rating becomes.

Can I make concrete with just sand and cement?

Can I make concrete with just sand and cement? No, you can’t make concrete with only sand and cement. Concrete isn’t considered concrete without aggregates like gravel and stone. It’s the aggregates that contribute to concrete having high strength.

What is a 1 2 3 mix for concrete?

A common concrete mixture is 1:2:3, that is 1 part cement, 2 parts sand, and 3 parts rock or gravel.

How many kg is 1m3 of cement?

conversion result for Portland cement:
From Symbol Result
1 cubic meter m3 =

1,505.74

How much is 1m3 in KG?

1 m3 / cu m = 1,000.00 kg wt.

How do I calculate volume of 50kg cement bag?

Lets see how can we calculate the volume of 1 cement bag by using all the values mentioned above.




How do I calculate volume of 50 Kg cement bag?

  1. Density of cement = 1440 kg/ m³
  2. 1 bag = 50 kg of cement.
  3. 1 m³ = 35.3147 cubic feet.
  4. 1 m³ = 10³ liters.

How much sand and cement do I need for 1m3 of concrete?

Typically, 1m3 of concrete is made up of 350Kg of cement, 700Kg of sand, 1,200Kg of chippings and 150 Litres of water.

How many 50kg bags of cement are in a cubic meter?

Procedure To Calculate Cement Bags In 1 Cubic Meter:

Weight of 1 bag cement = 50 kg. =0.0347 cum. = 6.25 bags.